High Quality PVA Glue D3 1kg Bottle

DESCRIPTION

A high quality, resin based wood adhesive for all wood bonding. It can be used internally and externally and provides a high strength, impact resistant bond.

Ideal for all general woodworking and joinery uses, furniture assembly and household DIY use. Can also be used in short term wet, damp and humid environments such as kitchens, bathrooms, washrooms and covered external applications.

Dries clear. Fast cure, initial set in just 10 minutes.

The product is also suitable for load bearing work as it conforms fully to the BS 14256 sustained load requirements.

D3: BS EN204, initial set in 10 minutes, hybrid resin formula, medium viscosity, BS 14256 approved product, paintable, easy to clean when uncured.

AREAS FOR USE:

• As a weatherproof/creep resistant wood adhesive, internally and externally.

DIRECTIONS FOR USE:

• Apply adhesive thinly to both surfaces. Do not over apply as this will slow down the curing process. Clamp surfaces together until adhesive dries. (off in 1-2 hours: full strength 8 hours). Support until fully cured (8 hours at 20°c). When fitting dowels, the adhesive should be applied to the holes.
• Suitable for radio frequency curing.

SURFACE PREPARATION:

• All surfaces must be clean, dry and free from grease.

LIMITATIONS:

• Not suitable for continuous immersion.
• Ensure wood doesn't contain excessive moisture (<15%).
• Do not use at temperatures below 10°c.
• Note: drying time is extended at low temperatures.
• Clean excess adhesive off glue line after clamping before adhesive dries with a damp cloth.
• Sand off any excess adhesive before staining the wood.
• Ensure sufficient clamping pressure, especially important with radio frequency bonding.
• Use on laminates: Only suitable for bonding small porous laminate strips. Do not use on non-porous or large areas of laminate.
• EXTERIOR USE: All glue joints must be protected with impervious paint system when dry.

STORAGE:

• To ensure safe storage of the product, containers should be well sealed to prevent evaporation of water and the formation of skin on the surface. The emulsion must be stored at a temperature above freezing. A temperature of 5-25°c for not more than 6 months is recommended. Higher temperatures will affect quality and cause the formation of crusts and skins, especially if the containers are not tightly closed or subjected to direct sunlight for long periods.
• During storage, slight separation may occur. (thin layer above thicker layer). This is an aesthetic rather than technical problem. In this case, shake well before applying.
• Typical shelf life in original, unopened packaging is 12 months. Once opened, shelf life will be reduced depending on storage conditions.

Write a review